SureCrete’s HS 300LV is a premium, high performance, single-component, 30% acrylic solids, low VOC (400 g/l), sealer designed for SureCrete overlays or other cement-based products.
- Coverage: Approximately 200-240 sq. ft. per gallon per coat
- VOC Rating: less than 400g/L
- UV Stable
- Single Component
- Vapor Permeable
- Formulated for Extreme Climates
- Water and Chemical Resistant
- 30% Acrylic Solids
- Slows Moisture Migration and Efflorescence
- Cold Weather, Low VOC Broom Finish Overlays
- Low VOC Sprayed Texture Coatings in Freeze/Thaw Climates
- Cold Weather Eco-Friendly Stamped Overlay Floors
- Slop-Trowel Green Exterior Textures in Freeze/Thaw Climates
- Cold Weather Pool Decks in Low VOC States
- Eco-Friendly Exterior Patio Overlays in Freeze/Thaw Climates
- Green Project, Cold Weather Driveways and Sidewalks
As with most acrylics it is vapor permeable and readily applies outside. However, HS 300LV is specially formulated for extreme climates where a low VOC sealer is required. Its nano-sealer technology deeply penetrates and reacts internally with cement, slowing moisture migration and efflorescence and intensifying bond capacity. Even in warmer climates HS 300LV’s slower evaporating solvents will not show a cotton candy effect before the applicator can finish a tight, smooth surface. A single coat application will provide a UV shield, enhance the beauty, and protect the surface of driveways, garage floors, patios, walkways, pool decks, and stucco.
HS 300LV was specially designed meet the challenges posed by some of the harshest freeze/thaw cycle climates in the world. In these difficult to deal with climates, many applicators and DIY weekend warriors alike have elected to forego sealing new concrete substrates, driveways and sidewalks altogether because of the excessively high de-lamination and subsequent failure rate associated with typical exterior acrylic sealers in these areas.
A large portion of northern areas deal with freeze and thaw cycles that can make the utilization of a typical protective exterior concrete acrylic sealer very problematic. Over time and multiple freeze/thaw cycles, most acrylic sealer will begin to delaminate and detach from the original substrate (typically an overlay with 30% solids acrylic coatings) and sometimes take chunks of the original concrete with it. For this reason, many have chosen to forego the application of an acrylic sealer altogether in these environments.
HS 300LV makes it possible to not only apply a sealer safely without worrying about it becoming weak and delaminating over time and multiple freeze and thaw cycles, but also to do so while adhering to strict VOC laws requiring solvent acrylic concrete sealers to vaporize less ecologically hazardous solvents into the air. You can be confident whether you are a homeowner looking to seal your brand new patio concrete overlay or an applicator sealing thousands of square feet of commercial pool decks, that this sealer will meet all your area’s legal requirements and give you a well protected, long lasting surface for years to come.