SureCrete Surfaces

• After sealer has cured, SureFinish may be applied by mop.
• Protect the mop bucket with a trashcan liner to prevent contamination of SureFinish.
• The mop should be a closed loop finish mop head to prevent leaving “strings” in the finish product.
• Fully saturate the mop head and wring out so that mop is damp, but not dripping.
• Apply thin - medium coats until desired initial gloss is achieved (usually 2-3 coats minimum).
• For optimum results burnish between coats using a white or non-aggressive floor pad.
• Between coats allow the floor to dry to the touch and wait 15 additional minutes.

General Surfaces

• Completely strip off old floor finish with heavy duty floor stripper.
• Remove all traces of stripper and old floor finish residue.
• Rinse with cool clean water until clear (min. 2 - 3 times).
• Allow floor to dry completely. Proceed as previous described with mop, etc.

Stone

Test a small area for adhesion, prior to full application, as stone surfaces are extremely variable in nature.

Marble

Remove any polished surface with sand screen prior to application.

Maintenance

• Dust mop daily using an untreated mop head to remove loose dirt, dust , and soil.
• Wet mop to clean ground in soil as needed.
• Machine scrub heavily soiled areas and reapply thin coats of SureFinish as needed.
• Heavily trafficked areas may require monthly reapplication.